456M Connector help | FerrariChat
Buy

456M Connector help

Discussion in 'Technical Q&A' started by Jagbuff, May 12, 2008.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Jagbuff

    Jagbuff Formula 3

    Jan 13, 2004
    2,267
    Site of US F1 Race!
    Full Name:
    Franck
    #1 Jagbuff, May 12, 2008
    Last edited by a moderator: Sep 7, 2017
  2. mwhitesell

    mwhitesell Formula 3

    Sep 17, 2006
    1,083
    Atlanta
    Full Name:
    Mark
    #2 mwhitesell, May 12, 2008
    I think I saw that right behind the stereo where all the switches were. You may have to take out the console to get to it. If you take out the ashtray screw and the two screws behind the switches and it all comes out.
     
  3. SonomaRik

    SonomaRik F1 Veteran

    Dec 15, 2006
    6,904
    Folsom, CA (formerly Sonoma)
    #3 SonomaRik, May 12, 2008
    at work and I have a non "M" anyway, but http://www.eurospares.co.uk/partTable.asp?M=1&Mo=367&A=2&B=19377&S= might be a good place to start.
     
  4. Jagbuff

    Jagbuff Formula 3

    Jan 13, 2004
    2,267
    Site of US F1 Race!
    Full Name:
    Franck
    #4 Jagbuff, May 12, 2008
    Thanks - will pull the switch panel out and see what I find.
     
  5. Jagbuff

    Jagbuff Formula 3

    Jan 13, 2004
    2,267
    Site of US F1 Race!
    Full Name:
    Franck
    #5 Jagbuff, May 13, 2008
    Shoot - still can't find the D*nm connector, I pulled the center section where the shifter and stereo is and can't find it. Also removed the side tunnel panel and can't find it. I even paid $295 for the original Electrical section of the factory workshop manual and the sensor is NOT identified... I am about to blow a gasket this is ridiculous...
     
  6. rauldejalapeno

    rauldejalapeno Karting
    BANNED

    Apr 21, 2008
    156
    Dallas, TX
    Full Name:
    Randy Bush
    #6 rauldejalapeno, May 13, 2008
    Your photos are great! When I get to work tomorrow, I'll see what I can find out for you. What year/assembly # is your 456?
     
  7. Jagbuff

    Jagbuff Formula 3

    Jan 13, 2004
    2,267
    Site of US F1 Race!
    Full Name:
    Franck
    #7 Jagbuff, May 14, 2008
    Last edited by a moderator: Sep 7, 2017
    It's a '01 GT - I have attached additional pics of the side and center console. I have checked around for loose connectors and I only have found the cell phone pre-wiring and old speaker connector, none of which match up to the sensor. It's ridiculous that Ferrari doesn't have it listed on the electrical wiring diagram - absolutely amazing! I have noticed that A/C controller is not shown either - makes me wonder if it is yet ANOTHER section of the manual that addresses the A/C system separately. Does anyone have the full set to confirm?
    TIA
    Franck
    Image Unavailable, Please Login
    Image Unavailable, Please Login
     
  8. rauldejalapeno

    rauldejalapeno Karting
    BANNED

    Apr 21, 2008
    156
    Dallas, TX
    Full Name:
    Randy Bush
    #8 rauldejalapeno, May 14, 2008
    Franck,
    What are those wire colors? Red & what else?

    Randy
     
  9. Jagbuff

    Jagbuff Formula 3

    Jan 13, 2004
    2,267
    Site of US F1 Race!
    Full Name:
    Franck
    #9 Jagbuff, May 14, 2008
    I will check tonight, I believe there 4 wires, Grey, Grey/Black, Red, and Black. I will confirm.
    THX
     
  10. Jagbuff

    Jagbuff Formula 3

    Jan 13, 2004
    2,267
    Site of US F1 Race!
    Full Name:
    Franck
    #10 Jagbuff, May 14, 2008
    I found it - it terminates on the right side of the condenser - the stereo guy must have pulled it run the wires.
     
  11. rauldejalapeno

    rauldejalapeno Karting
    BANNED

    Apr 21, 2008
    156
    Dallas, TX
    Full Name:
    Randy Bush
    #11 rauldejalapeno, May 15, 2008
    Woohoo! Good job! :)
     

Share This Page