87 TR Clutch Master Cylinder Replacement | FerrariChat
Buy

87 TR Clutch Master Cylinder Replacement

Discussion in 'Boxers/TR/M' started by tsyntax, Mar 20, 2011.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. tsyntax

    tsyntax Karting

    Dec 6, 2004
    88
    Baltimore, MD
    Full Name:
    Tony Syntax
    #1 tsyntax, Mar 20, 2011
    Please help! It appears I need to replace my clutch master cylinder. Can anyone give me the step-by-step instructions on how to do that? I have done all of the tests, and it points to that as the problem. The clutch and slave cylinder are relatively new with less than 2,000 miles on it.

    The biggest issue appears to me is access under the dash. I am sure I can pop out the retaining pin, but putting it back looks to be near impossible.
     
  2. Melvok

    Melvok F1 World Champ
    Owner Silver Subscribed

    Jul 25, 2008
    14,268
    Amersfoort, The Netherlands, Europe.
    Full Name:
    Mel
    #2 Melvok, Mar 20, 2011
    There was a posting about this topic recently: do a search first !
     
  3. tsyntax

    tsyntax Karting

    Dec 6, 2004
    88
    Baltimore, MD
    Full Name:
    Tony Syntax
    #3 tsyntax, Mar 20, 2011
    Melvok- I did a search and othing came up re: the steps for replacing it. Did get many hits discussing problems with clutch master and "slave" cylinder located in the bell housing. If you have any luck finding the thread, I would appreciate you sending it to me.

    Thnaks for responding.

    Tony
     
  4. tsyntax

    tsyntax Karting

    Dec 6, 2004
    88
    Baltimore, MD
    Full Name:
    Tony Syntax
    #4 tsyntax, Mar 21, 2011
    I made a little tool to slide the pin back into the slot of the new master cylinder and linkage. Bled the system and now works perfectly.
     

Share This Page