A angle grinder, a dremel and a Ferrari 348 dunt-dunt-dah

So tonight I started my little project to make more room for my tires. I have dont a little metal work before on my T/A and my father's show tractors so I wasn't to scared. Well I am lying I was but I knew it was just a matter of taking my time. So two hours later I have one wheel well done and if I dont say so myself it looks pretty factor and now I have more than enough room for my 25mm spacers from Ricambi on the rear even with my 85mm ride height.

So I started on the rear wheel and you tell me do you think the pictures below are from before or after my angle grinder and dremel work?

Second to last picture is my nice little cut outs. I should sell them on eBay.

The last picture shows the nice little suspension setup I have of course from my man Rob at Delta Vee of which I will have a review up on here after I get some more seat time. Need to finish the other 3 wheels and get all the electrical connection Stabilitant-22'ed as well as the oil changed. Bottom line so far its awesome!
Image Unavailable, Please Login
Image Unavailable, Please Login
Image Unavailable, Please Login
Image Unavailable, Please Login