Air filter cover stuck | FerrariChat
Buy

Air filter cover stuck

Discussion in 'Technical Q&A' started by cwwhk, Jan 16, 2005.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. cwwhk

    cwwhk Formula 3

    Nov 13, 2003
    1,535
    Hong Kong, Tokyo
    Full Name:
    Wayne
    #1 cwwhk, Jan 16, 2005
    Is there a trick to getting the air filter cover off of the 550? I tried to install some K&N filters today. Unscrewed the 4 screws and unclipped the 2 retaining clips, but that sucker won't budge. Tried the other side, same thing. Tried prying them off with screw driver, but no luck. If I force it anymore, the thin aluminum will probably deform.

    I assume the rubber edge on the air filter element has glued itself to the cover and airbox after being clamped in there for so long. So is there a spray or something that I can use to loosen them up? Thanks for your help in advance.

    Arrhhhh... a five minute job turns into pure frustration.

    Regards,

    cwwhk
     
  2. ferrarifixer

    ferrarifixer F1 Veteran
    BANNED

    Jul 22, 2003
    8,520
    Melbourne
    Full Name:
    Phil Hughes
    #2 ferrarifixer, Jan 17, 2005
    Never had the problem, but I guess WD40 or other penetrant will seep into it and loosen it.
     
  3. cwwhk

    cwwhk Formula 3

    Nov 13, 2003
    1,535
    Hong Kong, Tokyo
    Full Name:
    Wayne
    #3 cwwhk, Jan 18, 2005
    I was hoping I can avoid a mess with WD40 everywhere. Guess not then. Will try it this weekend. Maybe I'll drive around for a while first so that the engine bay is hot and hopefully the rubber edge of filter will soften and come off easier.
     

Share This Page