Had my Dino repainted and recently fitted the engine....The painters replaced the shockers at the same time.... Im not sure what is wrong but the anti rollbar hits the chassis rear cross member at the end of the roll bar curved part...and the little arm that connects the roll bar to the wishbone is at an angle of about 30 degrees....(I will try and post a pic) ...it almost seems that the ride height is too low..distorting the whole thing....as an approximate measure I find the distance from ground to top of boot edge at rear is 75cm's.... does this sound correct ....how can I tell if the shockers are the problem ....I wonder if anybody had a similar issue??
I think I can answer my own question....had I posted a picture it would have been obvious. Looking back at restoration pics it seems the two anti roll 'little arms' have been fitted upside down by the painters...mine are pointing upwards and it seems they should be pointing downwards...if the pics I see are correct ...we'll get there !
