Anyone know what header this is?

Ok, so first, sorry for the crappy pics. I don't have a lift. When I take it in I'll get better pics but I figured that with the triangular piece on the bottom it might be easier to figure out.

Also, the cats don't look stock either. Any thoughts or at least where I should crawl under the car to find any badging...

Note that the sheilding/cover is probably not from the header company. It is from Alloy Racing Covers.
Image Unavailable, Please Login
Image Unavailable, Please Login
Image Unavailable, Please Login
Image Unavailable, Please Login

 

headers could be fabspeed

and the cats look like hyperflows.

 

Hard to tell from those pics to be sure

 

So I found a cat that looks identical. It's at
Ferrari 355 - Left Hand Exhaust Catalyst After market 159946 ? Ferrari Parts Exchange

and Ricambi has the same part number
https://www.ricambiamerica.com/159946-euro-cat-sx.html

Are these what they seem? Just 2.7 motronic European cats? Anything good or bad about them?


-------------
Here is the best pic of the drivers side header. Still no clue.
Image Unavailable, Please Login
Image Unavailable, Please Login

 

Those cats are identical to my hyperflows. No idea on the headers

 

I concur on the hyperflows.

 

The cats in the "new" pic I got off the internet or the the ones from under my car?

Si there somewhere on your hyperflows where the name is engraved or etched? or some other markings?

 

I was speaking of the installed ones. I don't recall if they have a brand marking on them or not, but yours look like mine and I am reasonably sure they are hyperflows

 

My fabspeeds look different but mine are also coated, not sure what else they could be.

 

The cats on your car look like hyperflows. The ones you found on the web don't look like the ones on your car to me at all.

 

Correct. The welds are not ground. But as I said to Alex in email, my Evoflows look very close to Hyperflow so it could be those also.

 

So in any case the cats are not stock USA OEM and are probably high flow cats.

 

Those headers look like a custom job. Merge collectors fastened to the primary tubes with a mounting plate as opposed to TIG welds, and quite a sharp kink in one of the tubes...

 

I confirmed from all the comments, and comments from a previous owner that they are hyperflow cats and the manifolds seem to be "custom"