News

bleeding clutch throw-out bearing

Discussion in 'Technical Q&A' started by JIMBO, Feb 6, 2004.

  1. JIMBO

    JIMBO Formula 3
    Silver Subscribed

    Oct 31, 2003
    1,263
    Bradenton, Florida
    Full Name:
    Jim DeRespino
    In the process of performing the 30K service on my 1994 512TR I also opted to change the clutch and the hydraulic throw-out bearing. How do I "bench bleed" the new throw-out bearing assembly before I install it?
     
  2. To remove this ad click here.

  3. Diablo

    Diablo Formula Junior


    It's not necessary, just put it in and bleed normally(like brakes)

    Just make sure the line are clean.

    Good Luck
     
  4. JIMBO

    JIMBO Formula 3
    Silver Subscribed

    Oct 31, 2003
    1,263
    Bradenton, Florida
    Full Name:
    Jim DeRespino
    So, if I understand correctly, the fluid travels into the clutch thrust bearing assembly and back out the return line to the bleeder?
     

Share This Page