Carpet Attachment | FerrariChat
Buy

Carpet Attachment

Discussion in '308/328' started by Andrew McCrae, Sep 6, 2018.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Andrew McCrae

    Andrew McCrae Formula Junior

    Jun 5, 2016
    250
    Ireland
    #1 Andrew McCrae, Sep 6, 2018
    My drivers carpet (not mats) is not held down and is sliding forward as one would expect. When I lift it there are two fixings attached to the carpet with rivets showing along with 2 holes in the floor. It looks like they have pulled out. Carpets were renewed for a previous owner by a "trimmers" obviously not well. Questions are
    1. Did Ferrari use studs to affix floor carpets.
    2. How are they removed (pull?)
    3. How should the studs be attached to floor?
    I am trying to use the original factory method so trying to find that out. Thanks All.
     
  2. absostone

    absostone F1 World Champ
    Silver Subscribed

    Jul 28, 2008
    10,182
    #2 absostone, Sep 6, 2018
    Tenax fasteners?
     
  3. Andrew McCrae

    Andrew McCrae Formula Junior

    Jun 5, 2016
    250
    Ireland
    #3 Andrew McCrae, Sep 6, 2018
    Maybe, Top surface of carpet is like a carpet button cover. No idea how to release. I gather they are very non standard?
     
  4. absostone

    absostone F1 World Champ
    Silver Subscribed

    Jul 28, 2008
    10,182
    #4 absostone, Sep 6, 2018
    what car is it
     
  5. Alex308qv

    Alex308qv Formula Junior

    Jul 1, 2016
    406
    PA
    Full Name:
    Alex
    #5 Alex308qv, Sep 6, 2018
    Believe it's an '81 308? Not sure what was done then, but on my '85 QV the carpets are only attached with a velcro strip back where they tuck under the seats. Yes, they move around a bit, but as long as you don't yank the velcro apart it's fine.
     
  6. Jdubbya

    Jdubbya The $10 Trillion Man
    Silver Subscribed

    Dec 28, 2003
    43,693
    Hell's waiting room
    Full Name:
    John
    #6 Jdubbya, Sep 6, 2018
    Nothing like that on my '78 when I did it. Existing carpet, which I know was not factory, was glued down. I did the same with new carpet. No idea how you'd get the carpet itself to stay down with only two points holding it.
     
  7. Andrew McCrae

    Andrew McCrae Formula Junior

    Jun 5, 2016
    250
    Ireland
    #7 Andrew McCrae, Sep 7, 2018
    It's a 308 GTB built 1980. I only picked it up about 3 weeks ago and the drivers side carpet was wet after driving it home. I suspect two holes drilled in the floor just in front of the seat is non standard as are the fasteners.
     

Share This Page