dash trim | FerrariChat
Buy

dash trim

Discussion in '206/246' started by barchettaboy, Dec 13, 2011.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. barchettaboy

    barchettaboy Rookie

    Nov 11, 2011
    16
    Sequim WA
    Full Name:
    Darryl Fling
    #1 barchettaboy, Dec 13, 2011
    Hi everyone
    I am looking for a source for the rubber edge trim that finished off the gauge cluster aluminum, the car I am working one is torn. But I do not see it listed at any of the normal parts places, any thoughts?

    Darryl
     
  2. HMB-Dino

    HMB-Dino Formula 3
    Silver Subscribed

    Jun 28, 2010
    2,282
    Pebble Beach, CA
    Full Name:
    RonG
    #2 HMB-Dino, Dec 13, 2011
    I may have that material (used)...it was actually applied around the edge of the front grill on my Dino when I bought it. Since I removed my instruments to get `refreshed', I had the opportunity to compare...sure looked the same to me. What length do you need, give or take?
     
  3. swift53

    swift53 F1 Veteran
    Rossa Subscribed

    Nov 17, 2007
    8,291
    E.S.
    Full Name:
    Alberto
    #3 swift53, Dec 13, 2011
    Ron, do you have dimensions you might post?
    Thank you.

    Regards, Alberto
     
  4. barchettaboy

    barchettaboy Rookie

    Nov 11, 2011
    16
    Sequim WA
    Full Name:
    Darryl Fling
    #4 barchettaboy, Dec 15, 2011
    Hi Ron
    thanks for your response, it takes about 43 inches to get around the dash panel, I will gladly pay you for it. As I have had no luck finding it anywhere so far, that would be great,
    How much do want for it ?
    Darryl
     
  5. HMB-Dino

    HMB-Dino Formula 3
    Silver Subscribed

    Jun 28, 2010
    2,282
    Pebble Beach, CA
    Full Name:
    RonG
    #5 HMB-Dino, Dec 15, 2011
    Let me dig it up (should be easy to find...if I remember) and I'll post the length.
     
  6. HMB-Dino

    HMB-Dino Formula 3
    Silver Subscribed

    Jun 28, 2010
    2,282
    Pebble Beach, CA
    Full Name:
    RonG
    #6 HMB-Dino, Dec 15, 2011
    I have a single piece that's 67 inches long. Almost thought I tossed it when it wasn't in any of the `obvious' locations. This only goes to show...never toss anything that you take off a Dino, because somebody out there probably needs it!
     
  7. barchettaboy

    barchettaboy Rookie

    Nov 11, 2011
    16
    Sequim WA
    Full Name:
    Darryl Fling
    #7 barchettaboy, Dec 16, 2011
    Hey Ron
    I will buy it, if you will sell it, how much do you want for it.
    If you could send it to me at

    D & B Enterprises
    2869 Lotzgesell rd.
    Sequim WA. 98382

    I will shoot you a check
    Darryl
     
  8. HMB-Dino

    HMB-Dino Formula 3
    Silver Subscribed

    Jun 28, 2010
    2,282
    Pebble Beach, CA
    Full Name:
    RonG
    #8 HMB-Dino, Dec 18, 2011
    PM/email sent.
     
  9. omgjon

    omgjon F1 Rookie
    Owner Rossa Subscribed

    Feb 13, 2005
    3,569
    Spicewood, Texas
    Full Name:
    Jon Gunderson
    #9 omgjon, Nov 25, 2012
    Any more out there anywhere??
     

Share This Page