Daytona speedometer cable | FerrariChat

Daytona speedometer cable

Discussion in 'Vintage (thru 365 GTC4)' started by jnk, Jun 24, 2018.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. jnk

    jnk Formula Junior

    Nov 12, 2010
    341
    #1 jnk, Jun 24, 2018
    I was driving my Daytona today and the speedometer went from 65 down to near zero. Clearly there’s no odometer movement either. Can someone take a picture of where the speedometer attaches to the transaxle for me please. I can’t seem to find that spot.
    I checked behind the speedometer and it’s attached tightly there. Before I get an entire new cable I just want to make sure that it didn’t detach from the transaxle.
     
  2. TTR

    TTR F1 Veteran
    Rossa Subscribed

    Mar 29, 2007
    5,200
    Riverside, CA
    Full Name:
    Timo
    #2 TTR, Jun 24, 2018
  3. jnk

    jnk Formula Junior

    Nov 12, 2010
    341
    #3 jnk, Jun 24, 2018
  4. Dogdish

    Dogdish Formula Junior

    Dec 27, 2005
    367
    Denver
    #4 Dogdish, Jun 25, 2018
    My angle drive that Timo has circled broke the output shaft that goes into the transaxle. If that is broken, PM me, I made a few of those tiny driveshafts.
    So far so good, as I used soft steel. Didn't think I needed harder steel.
     
  5. John Vardanian

    John Vardanian F1 Rookie

    Jul 1, 2004
    3,046
    San Francisco Area
    Full Name:
    John Vardanian
    #5 John Vardanian, Jun 25, 2018
    Often a binding cable can damage the angle drive.

    john
     

Share This Page