DAYTONA VISORS

After all these years of devoted service, I'm afraid the visors on my Daytona have given up the ghost. I've tried tightening that screw in the upper left-hand corner, but the visor keeps falling in my face and I need a solution. Does anybody make reproductions or does anyone have suggestions on how to remedy this problem? I fear it will be difficult to get an exact replica of the existing visors. Thank you all for your help.

Steve.

NB: X-posted with TY.

 

Here are two pictures. One shows the screw which, interestingly enough, I was able to tighten some today and it will work (as long as it will work!). The other shows the rubber hose I've used in the socket. However, in the picture you cannot see that the steel rod does not reach all the way to the receptacle.
Image Unavailable, Please Login Image Unavailable, Please Login

 

Tom, send me a p.m. with a price and availability. Ideally, they would be white on one side and black on the other. Thanks, Steve.
<[email protected]>

 

Thank you all for helping me with this problem. I have previously, and on the number of occasions, tightened the screw in the upper left-hand corner of the visor. It has always worked, but only for some period of time. I tightened it up once again and drove the car today, and had no problems. So, since it works at the moment, I'm reluctant to do anything else. Sometimes "the enemy of good is better". Steve.

 

@PDB that is most interesting in the next time it fails, I will check into it. Thanks again. Steve.

 

@PDB mine are parallel, as they should be, but the rod may have pulled too far to the left (driver's side) thanx again. s