Did I screw up? | FerrariChat

Did I screw up?

Discussion in 'Texas' started by donald, Dec 10, 2004.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. donald

    donald Karting

    Joined:
    Aug 11, 2004
    Messages:
    197
    Location:
    Dallas, Texas
    Full Name:
    Don
    Earlier in the week I ordered a pedal set, dead pedal, and chrome shift knob from Hill Engineering.

    I hope I ordered the right shift knob .....it is chrome engraved with the shift pattern and there were two options in size: 47 mm and 50 mm. I ordered the 47mm. Does anyone know if this is the same size as the stock shift knob? I hope so!
     
    donald, Dec 10, 2004
    #1
  2. WJHMH

    WJHMH Two Time F1 World Champ Silver Subscribed

    Joined:
    Sep 5, 2001
    Messages:
    26,441
    Location:
    Panther City, Texas
    Full Name:
    WJHMH
    Hmm. Thats a good question. Some kits come with spacers/gaskets in order to get the better fit. Post some photos when you get your kit in.
     
    WJHMH, Dec 10, 2004
    #2
  3. GrigioGuy

    GrigioGuy Splenda Daddy Lifetime Rossa Owner

    Joined:
    Nov 26, 2001
    Messages:
    33,089
    Location:
    E ' ' '/ F
    Full Name:
    Snike Fingersmith
    The thread inside will be the same in either case.

    I belive the smaller one is the correct stock size. I have a larger one that is the size of a 355/360 shift knob, and I think it was the 50mm
     
    GrigioGuy, Dec 10, 2004
    #3
  4. jimpo1

    jimpo1 Two Time F1 World Champ Owner Silver Subscribed

    Joined:
    Jul 30, 2001
    Messages:
    24,897
    Location:
    Dallas, TX
    Full Name:
    Jim E
    I ordered the 50mm and actually prefer it to the stock size. It's quite a bit larger. Even if you 'screwed up', I think you'll be happy with it.
     
    jimpo1, Dec 10, 2004
    #4
  5. 400SPYDER

    400SPYDER F1 Rookie

    Joined:
    Jul 7, 2004
    Messages:
    3,473
    Location:
    Kent, England
    Full Name:
    kevan
    Don

    The owner of Hill Engineering is a memeber of Fchat - 348paul - you could PM him from here:-

    http://ferrarichat.com/forum/member.php?u=101

    Cheers Kevan
    :) See you down the road - with huge grins on all our faces:)
     
    400SPYDER, Dec 10, 2004
    #5

Share This Page