Dino 246 GT Air Scoop

I have a fibreglass moulding which I assume fits to the RHS air intake in the engine bay. This piece came with the car but has never been fitted. I cannot find the moulding in the parts book or from any of the online sellers.

While I have the engine removed I wanted to try and fit the moulding, but it is not clear how it should be attached.

A couple of questions which I hope someone can help with, 1) does the moulding belong to the car, and 2) if yes, how is it supposed to be fitted ? If anyone has a photo that would be great.

I have attached a few photos to better explain. Grateful for any advice on this. I have scoured the online images but cannot find anything.

Thanks
Mike


Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login

 

That part appears to be home made, and not correct. Best I can do, as probably a potentially modification of the airbox ?

Regards, Alberto

 

That is the OEM vent for the front blower motors that feed fresh air to the cabin. There should be 2 of them (one per side and directional) and they fit between the inside of the lower nose and the fan motors. The molding is not a shaped piece but rather bought by the roll. Some cars had it stapled and some adhered.

Here is a link to the foam profile. It is available from many suppliers and this is what it looks like for reference:

https://mrfiat.com/collections/glass-and-seals-112/products/ferrari-dino-206-246-gt-rubber-bulk-under-fender

 

Thanks for the advice, it fits perfectly on the front right hand side. I now need to try and find one for the left hand side