Distributor cap removal | FerrariChat
Buy

Distributor cap removal

Discussion in '308/328' started by stev4266, Sep 20, 2012.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. stev4266

    stev4266 Karting

    Mar 24, 2010
    186
    R.I.
    Full Name:
    steven gregson
    #1 stev4266, Sep 20, 2012
    I am trying to remove the wires from the cap. I took out the plug wires with the screw inside the cap at each location. The problem is the coil wire in the center. It doesn't have a screw head on it. How does that one come out? Is it so worn out the slot is gone?

    Thanks in advance.
     
  2. Tifosi2011

    Tifosi2011 Formula Junior

    Apr 3, 2011
    307
    Burnaby, BC Canada
    Full Name:
    John
    #2 Tifosi2011, Sep 20, 2012
    No, it's not worn out. In fact, it's directly beneath the spring loaded centre piece. All you need to do is back it out slowly by turning it to the left.

    The harder part is putting it back in. That's where careful spring manipulation comes into play. Use a very small slot head screwdriver (the smallest one you can find), and carefully reintroduce the sring back into the opening while slowly turning it to the right.

    I've tried my best not to be difficult in my explanation. I hope I've assisted you.
    Good luck
     
  3. stevel48

    stevel48 Formula 3

    Jan 4, 2005
    1,998
    Metrowest MA
    Full Name:
    Steve (85 308 Owner)
    #3 stevel48, Sep 20, 2012
    You may need a new carbon brush as well. It's what fits in that center hole covering the screw.
     
  4. mwr4440

    mwr4440 Five Time F1 World Champ
    Rossa Subscribed

    Jun 8, 2007
    57,962
    Bavaria, The 'Other' Germany
    Full Name:
    Mark W.R.
    #4 mwr4440, Sep 21, 2012
    Yep. Works just fine.
     

Share This Page