Does anyone have an extra Wheel Spinner for a 330 GTC?

Sorry I do not but you might specify right or left side?

 

... and perhaps place this request in “Classifieds” as a “Wanted” ad instead here.

 

http://www.borraniamericas.com/html/knock_offs.html

 

Well, perhaps I'm mistaken, but I thought those sections were specifically meant for these types (Buying/Selling/Wanted Cars/Parts/etc) of inquiries.

 

Just be wary, Borrani wheel spinners on a Daytona will only fit the wire wheels and will not fit the Alloy wheels, so if you are looking for one for wires the Borrani ones should be fine but MAY not be for other types of wheel.

I am not sure if this is the case for a 330 GTC, but please check to be sure

 

The straight-ear spinner in the GTC photo for the square-hole Campagnolo magnesium wheel is not a Borrani knock-off. I believe those spinners are also Campagnolo. The straight-ear is correct for the magnesium wheel. For Boarrani wire wheels on a GTC, yes use the angle ear Borrani spinner.

 

Sorry to further derail this thread off topic, ...
...but there appear to be at least two different depths/lengths for 42mm spline centers and wheel nuts commonly found and used on Daytona wheels.
Here's a sample of two different (U.S. market) nuts with different "reach".
I haven't quite figured how and whether or not this applies to Euro ("eared") nuts, Borranis, Cromodoras, standard and/or non-standard (i.e. 8" or 9") width wheels, etc.

Image Unavailable, Please Login