Engine cradle cross member bend or not?

Cost?

 

I know it's hollow inside, but are the ends open?

 

I did construction work for years, never think a piece of wood is straight! It my be very close, but not perfect. If anything get a 4 ft level and try again, not exact but close. Even if it is bent the little that you show in the pictures, it really wouldn't be enough to be concerned with.

 

Thanks. Let me know if you decide to sell it.

 

It's not really bent. It has a dent towards the middle. I'm assuming someone attempted to use it as a lift point and realized it's not strong enough. I have OCD... I want it perfect...

If you don't mind, how much was it?

 

Hi

I found this.

T-WEST | ???? | TWS | Body Parts | ???????????????????

This is for 355, but seems compatibles for 344.

 

That's not wise. Plenty of good places, no need to use that spot.

 

For a thousand bucks? I think I could have someone fab up one in aluminum or better for less. Not billet, but strong enough.

 

Its a simple metric steel tube 20x50 mm thin wall, easy as heck to make. I just bought a new one as I am lazy

 

Harbor fright has a cross bar for most floor jacks $39.00 it is adjustable and you can lift your car from both ends of that cross bar.

 

Yep,yep,yep. Love mine.
Image Unavailable, Please Login

 

That is a great idea.

 

Yeah - But then you don't get to be members of the bent cross-member club!

(Thanks to a previous owner/servicing garage, I qualify for membership to the club! )

 

I am wayyyy too low to use that

 

What's the pn? I know they made a challenge cross member that was heavier duty, perhaps that's it?