F-Car, Different Lug Nut Chart. Does one exist? | FerrariChat

F-Car, Different Lug Nut Chart. Does one exist?

Discussion in 'Ferrari Discussion (not model specific)' started by Sleestak, Feb 15, 2022.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Sleestak

    Sleestak Karting
    Silver Subscribed

    Jun 18, 2014
    91
    Coeur d'Alene, Idaho
    Hello, I had a custom set of wheel made for my 88 TR. Unfortunately, my lug bolts are too short. So, is there a list or chart that shows all the shaft lengths and cross references the factory part number?

    Thanks in advance

    Eric
     
  2. Steve Magnusson

    Steve Magnusson Two Time F1 World Champ
    BANNED Lifetime Rossa

    Jan 11, 2001
    26,822
    30°30'40" N 97°35'41" W (Texas)
    Full Name:
    Steve Magnusson
    Easier (and cheaper ;)) to just buy the length lugbolts that you need from Hill Engineering/Ricambi America.
     
  3. Sleestak

    Sleestak Karting
    Silver Subscribed

    Jun 18, 2014
    91
    Coeur d'Alene, Idaho
    ok, I’ll check there. Thank you
     
  4. Ricambi America

    Ricambi America F1 World Champ
    Sponsor Owner

    The standard TR wheels (not centerlock early wheels, not 512TR/M wheels) use a lug with 30mm head, 40mm length from the end of the bolt to the start of the conical head (and 20mm of that is threaded). The bolt size you need will obviously be dependent on whatever custom wheel you've got.
     
  5. Redneck Slim

    Redneck Slim Formula 3
    Rossa Subscribed Silver Subscribed

    Mar 10, 2011
    1,653
    Palo Alto,CA,USA
    Full Name:
    Walt Kimball
    The custom wheels for my Portofino had shallower pockets than the stock wheels,so I needed shorter bolts (32 mm versus about 50 mm stock). I got the new bolts right away from Formula Dynamics in Las Vegas.
     

Share This Page