F12 coilspring rates? | FerrariChat

F12 coilspring rates?

Discussion in 'F12/812' started by Ozaki, Jan 28, 2016.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Ozaki

    Ozaki Rookie

    Joined:
    Jan 28, 2016
    Messages:
    3
    Location:
    Japan
    Full Name:
    Rick Watanabe
    Hello everyone,

    I have a white F12 with the carbon option lights, and the SCM-E, but the car still rides a little high for my liking,

    Ive used the search button on the forum and internet and couldn't come up with much,

    Does anyone on here know the spring information, rate, etc ?
    I would like to get another set so the car can sit a bit lower on the front, as factory sits too high for me, anyone else thing it sits a little high?

    thanks

    Ozaki
     
  2. AutobahnAndTrack

    AutobahnAndTrack Formula Junior

    Joined:
    Dec 31, 2014
    Messages:
    307
    Location:
    Frankfurt, Germany
    Full Name:
    Stefan G
    Novitec sells lower springs.

    Anyone knows if they are also more firm than stock?

    Would like to have spring rate (+30%) and coil magnetho setup of TdF.
     
  3. Caeruleus11

    Caeruleus11 F1 World Champ Rossa Subscribed

    Joined:
    Jun 11, 2013
    Messages:
    11,609
    Novitec is probably the way to go. Their springs are typically 15% stiffer than stock. In speaking with their dealers they say this is safely within the tolerance of the standard suspension setup.
     
  4. tazandjan

    tazandjan Three Time F1 World Champ Lifetime Rossa Owner

    Joined:
    Jul 19, 2008
    Messages:
    39,164
    Location:
    Clarksville, Tennessee
    Full Name:
    Terry H Phillips
    Ride height is adjustable on the F12 within a range of ~15-20 mm. Your dealer or suspension shop with Ferrari experience can do it for you. A full suspension alignment front and rear will be necessary after adjusting ride height, which will require a selection of shims for setting camber.

    First check your ride height to make sure it is set to the factory settings. Should be 134 mm + or - 5 mm front and 151.7 mm + or - 5 mm rear, measured from the pads on the bottom of the frame near the suspension.

    No spring rates in the F12 WSM.
     

Share This Page