F366 wiring diagram | FerrariChat

F366 wiring diagram

Discussion in 'United Kingdom' started by 1spud0, Jul 23, 2024.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. 1spud0

    1spud0 Rookie

    Nov 29, 2013
    9
    Plymouth UK
    Full Name:
    Jonathan Taylor
    Hi
    Does anyone have a decent wiring diagram for a 355 2.7 left hand drive.
    Thanks
     
  2. tomw

    tomw Formula 3
    Silver Subscribed

    Feb 25, 2004
    2,413
    London
    Full Name:
    Tom
    @Qavion is often incredibly helpful in this area. Perhaps he can help? (also try the 355 section)
     
    Qavion likes this.
  3. Qavion

    Qavion F1 World Champ
    Silver Subscribed

    Feb 20, 2015
    14,277
    Sydney
    Full Name:
    Ian Riddell
    I have about 16 individual diagrams. What part of the car are you having issues with? Exterior lights? ABS? HVAC? Roof? Windows? Doorlocks? Instruments? Suspension? Engine? Battery/alternator?
     
    ntatfas likes this.
  4. 1spud0

    1spud0 Rookie

    Nov 29, 2013
    9
    Plymouth UK
    Full Name:
    Jonathan Taylor
    Hi
    Thanks for the reply.
    1st problem is fuel pump not working, im guessing its going to be the pump as the car has been stood for a good while but there is no power to either of the fuses but there is power to the relay on pins 30 and 86 so i would like to investigate a bit further until i can get car on ramps to get fuel pump out and check it.
    Also there is an air bag issue which needs looking at, and to top it of there was an after market immobaliser fitted which went fauly and i had to leave the car with a garage to sort this out (this is going back a few years) so when i pulled the fuse board out there is a large connenctor there which has has cables cut and wires taped together which is not good, the car has been running after this was done but want to tidy this up.
    If you could help with diagrams that relate to these areas it would be appreciated.
    Thanks
     
    Qavion likes this.
  5. Qavion

    Qavion F1 World Champ
    Silver Subscribed

    Feb 20, 2015
    14,277
    Sydney
    Full Name:
    Ian Riddell
    #5 Qavion, Jul 26, 2024
    Last edited: Jul 26, 2024
    OMG.... Sounds like a few months work there.

    The fuel pump is shown in this diagram:

    https://www.dropbox.com/t/MPoraoLZ7CKl7vmY

    Unfortunately, the diagrams don't show relay pin numbers. I assume pin 30 is live battery power and pin 86 is power coming from relay O (with the ignition key ON)

    Image Unavailable, Please Login
    Pin 85 will be a ground signal from the Motronics ECU to energise the coil. If I recall correctly, when the ECU sees the engine at 30rpm during start, it provides the ground. The speed signal is provided by the Left Bank crank sensor (according to the following diagram)

    https://www.dropbox.com/t/NHxT8v2d5TFuHyxd

    The left bank crank sensor also provides a signal to the tachometer.

    Links expire in 6 days.

    Note the pink/yellow (SG) jumper wire on connector 59302. Connector 59302 is behind the passenger footwell relay panel:

    Image Unavailable, Please Login

    If there has been an aftermarket immobiliser fitted, the installer may have inserted wiring into the jumper wire?
     
  6. Qavion

    Qavion F1 World Champ
    Silver Subscribed

    Feb 20, 2015
    14,277
    Sydney
    Full Name:
    Ian Riddell
    Unfortunately, I don't have a diagram for the Airbag System.

    Note that the photo above shows standard wiring on the 2.7. Is this the connector you're referring to? There are cut wires and wires taped together. This is normal.
     
  7. Qavion

    Qavion F1 World Champ
    Silver Subscribed

    Feb 20, 2015
    14,277
    Sydney
    Full Name:
    Ian Riddell
    By the way, I don't normally visit the United Kingdom forum. If you have any further questions, please post on the FerrariChat 348/355 forum ;)
     
  8. 1spud0

    1spud0 Rookie

    Nov 29, 2013
    9
    Plymouth UK
    Full Name:
    Jonathan Taylor
    OK will do, many thanks
     

Share This Page