Ferrari 328 reaction tie rod | FerrariChat
Buy

Ferrari 328 reaction tie rod

Discussion in '308/328' started by bamrongpol, Dec 30, 2016.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. bamrongpol

    bamrongpol Rookie

    May 9, 2014
    17
    Bangkok Thailand
    Full Name:
    Dumrong Bamrongpol
    #1 bamrongpol, Dec 30, 2016
    Last edited by a moderator: Sep 7, 2017
  2. LostAussie

    LostAussie Formula Junior

    Jun 13, 2013
    719
    Piemonte
    Full Name:
    Stuart
    #2 LostAussie, Dec 30, 2016
    According to Ricambi:

    - 117973 is for a USA 308QV and all 328s.

    - 111888 is for non-USA 308QV, Mondial 3.2, and Mondial QV.
     
  3. bamrongpol

    bamrongpol Rookie

    May 9, 2014
    17
    Bangkok Thailand
    Full Name:
    Dumrong Bamrongpol
    #3 bamrongpol, Dec 30, 2016
    Dimension exactly same?
     
  4. LostAussie

    LostAussie Formula Junior

    Jun 13, 2013
    719
    Piemonte
    Full Name:
    Stuart
    #4 LostAussie, Dec 30, 2016
    Not sure, I'm guessing something's different between the two part numbers.
     
  5. Brian A

    Brian A F1 Rookie

    Dec 21, 2012
    3,150
    SanFrancisco BayArea
    Full Name:
    1983 US 308 GTS QV
    #5 Brian A, Dec 31, 2016
    On my 1983 US-spec QV, the length, measured bolt center to bolt center, is 243 mm. The internal width of the engine-side bracket is 47 mm. The width of the rear bushing is also 47 mm.

    If someone (else) measures the other type, you'll have your answer.
     
  6. maurice70

    maurice70 F1 Rookie

    Jan 25, 2004
    4,334
    Sydney
    Full Name:
    maurice T
    #6 maurice70, Jan 1, 2017
    These are the dimensions on my 87' 328 GTS Euro model:

    Overall Length 290mm

    Bolt centre to centre 245mm

    Length of U bracket 75mm

    Inner width of U bracket. 47mm

    Inner width of Bush Bracket 45mm

    Length of steel shaft joining U Bracket and Bush 163mm

    Hope this helps..
     

Share This Page