Ferrari 348 Fabspeed Headers | Page 2 | FerrariChat

Ferrari 348 Fabspeed Headers

Discussion in '348/355' started by errico, Apr 1, 2014.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Evan.Fiorentino

    Evan.Fiorentino F1 Rookie

    Aug 23, 2005
    2,854
    South East Florida
    Full Name:
    Evan
    I should be able to have the Video of the full Fabspeed exhaust uploaded today. I was actually surprised that the X-pipe was very driver friendly! I would say that the Cappy 3 even had a little bit more volume (definitely more drone, not to down talk the cappy 3, it just has a different goal in mind)

    The full exhaust has a great sound that give you a very nice tone without being TOO much. It was also very hard to pick up on our microphones, go figure.
     
  2. Evan.Fiorentino

    Evan.Fiorentino F1 Rookie

    Aug 23, 2005
    2,854
    South East Florida
    Full Name:
    Evan
    #27 Evan.Fiorentino, Apr 7, 2014
    Last edited: Apr 7, 2014
    Not sure if you guys had seen this old video or not. This is with the Fabspeed Headers, catbypass pipes and a Capristo Rear muffler. Sounds very good!

    [ame]http://www.youtube.com/watch?v=EvWEpN7D1xc[/ame]
     
  3. zakeen

    zakeen Formula Junior

    Aug 29, 2004
    989
    Czech Republic
    sounds very nice. indeed.
     
  4. DonJuan348

    DonJuan348 F1 Rookie
    Owner

    Aug 5, 2008
    4,442
    Taxing Jersey
    I'm curious will the fit Mondial t ? Also, how much added horsepower ?
     
  5. Evan.Fiorentino

    Evan.Fiorentino F1 Rookie

    Aug 23, 2005
    2,854
    South East Florida
    Full Name:
    Evan
    #30 Evan.Fiorentino, Apr 9, 2014
    Last edited: Apr 9, 2014
    The sound is not very well captured from the go-pro cameras. The sound is much more high pitched in person with a very distinctive V8 sound in the lower RPM. It does not scream like the Capristo, however it makes more power and sounds more Challenge like. This car also has the sport cats and not the Catbypass pipes on it.

    [ame]http://www.youtube.com/watch?v=hhC3A5FS2jw[/ame]
     
  6. ernie

    ernie Two Time F1 World Champ
    Lifetime Rossa Owner

    Nov 19, 2001
    22,620
    The Brickyard
    Full Name:
    The Bad Guy
    Final numbers?
     
  7. dkny

    dkny Formula Junior

    Jun 8, 2005
    575
    Kingston, NY
    Full Name:
    dave
    Once I get it back, I'll have to get a few videos around the rev limiter to hear her scream
     
  8. Evan.Fiorentino

    Evan.Fiorentino F1 Rookie

    Aug 23, 2005
    2,854
    South East Florida
    Full Name:
    Evan
    Hey guys,

    After today the introductory price on the 348 Supersport X-pipe will be raised back to full retail ($100 difference) so if you were thinking of ordering, make sure you place the order today and save!

    Evan
     
  9. Evan.Fiorentino

    Evan.Fiorentino F1 Rookie

    Aug 23, 2005
    2,854
    South East Florida
    Full Name:
    Evan
    Just finished two sets of 348 headers for stock! They wont last long ;)
     
  10. angelis

    angelis F1 Veteran
    Owner

    Jun 18, 2004
    6,400
    London, England
    Full Name:
    Sy
    Can you replace headers whilst engine is still in?
     
  11. gothspeed

    gothspeed F1 World Champ

    May 26, 2006
    10,244
    U.S.A.
    Full Name:
    goth
    Are these 348 manifolds a direct retro-fit for stock?
    the collector looks a little long ........... but could just be the way the primaries wrapped .... :eek:
     
  12. Evan.Fiorentino

    Evan.Fiorentino F1 Rookie

    Aug 23, 2005
    2,854
    South East Florida
    Full Name:
    Evan
    Yes! You have to remove the rear wheels and liners, but the engine does not have to come out.

    These will bolt up with no problems. I will post some more detailed photos later
     

Share This Page