first drive | FerrariChat
Buy

first drive

Discussion in '365 GT4 2+2/400/412' started by bundas, Jul 8, 2007.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. bundas

    bundas F1 Veteran
    Owner

    Dec 31, 2005
    7,090
    lexington ky usa
    Full Name:
    mitchell barnes
    #1 bundas, Jul 8, 2007
    after a month at shop, fixing all little things, i drove my 84 400i for first time. 90+ temp. air not up to task. so i just put top down and lisened to the sound. wonderful! made about 75 miles when something stopped working. will not pull properly, except in n. is auto trans. drove home ok, but without power normally available.
     
  2. Ashman

    Ashman Three Time F1 World Champ
    Owner Silver Subscribed

    Sep 5, 2002
    33,240
    MA
    Full Name:
    John
    #2 Ashman, Jul 8, 2007
    check fuel pump relays and clean contacts?

    John
     
  3. 400 gts

    400 gts Karting

    Apr 4, 2007
    58
    West Palm Beach, FL
    Full Name:
    B.I.
    #3 400 gts, Jul 10, 2007
    You may also look at the fuses for the fuel pumps. Both of mine were poorly seated, and after I cleaned the connections, the car ran great. Also you should look at the wire connection box located at the bottom of the relay assembly, located at the passenger side. This is a plastic box with connectors inside. Mine burned and I have since replaced the box with a screw terminal unit. It greatly improved on how the engine is running. I think it was too much resistance in the burned out terminal box.

    400 gts.
     

Share This Page