flywheel rebuild help | FerrariChat

flywheel rebuild help

Discussion in '348/355' started by ahrddr, Mar 22, 2010.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. ahrddr

    ahrddr Rookie

    Aug 1, 2007
    45
    So Cal/N. VA/FL
    Hey guys-trying to rebuild my 355 flywheel. Going fine but ricambi doesnt sell the large o-ring that goes around the plate attached to the flywheel (that keeps the kluber grease in). Anyone have a good source for buying this? (hope).
    Also-how critical is it to have the clutch alignment tool? I'm not too keen on the idea of laying out $100+ for a piece of plastic I will probably use once or twice. Thanks in advance for any help you can provide.
     
  2. plugzit

    plugzit F1 Veteran
    Silver Subscribed

    Dec 1, 2004
    7,782
    Redondo Beach, CA
    Full Name:
    Bruce Bogart
    o-ring: GT Car parts 623 780-2200
    Alignment tool use (deep) sockets-you'll find some that have the same outside diameter as the clutch and flywheel that make a good fit.
     
  3. Motob

    Motob Formula 3
    Professional Ferrari Technician

    Nov 11, 2003
    2,370
    Frederick, Maryland
    Full Name:
    Brian Brown
    You can buy metric o-ring material at Mc master Carr, or a bearing supply house. You cut the old o-ring. lay it flat, cut the new o-ring to the same length and glue it together with O-ring glue (super glue).
     
  4. ahrddr

    ahrddr Rookie

    Aug 1, 2007
    45
    So Cal/N. VA/FL
    THANKS TO ALL! GT PARTS had everything i needed! appreciate the help. Now just waiting for all the stuff to get here and put it all back together.
     
  5. plugzit

    plugzit F1 Veteran
    Silver Subscribed

    Dec 1, 2004
    7,782
    Redondo Beach, CA
    Full Name:
    Bruce Bogart
    Glad to help! Now you're obligated.....spend $15 and subscribe, fill out your profile, and post pics of the process!
     

Share This Page