Forged piston bore clearance | FerrariChat
Buy

Forged piston bore clearance

Discussion in 'Technical Q&A' started by duck.co.za, Apr 12, 2008.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. duck.co.za

    duck.co.za Formula 3

    Jan 9, 2007
    1,007
    Cape Town South Afri
    Full Name:
    Dave
    #1 duck.co.za, Apr 12, 2008
    I have a set of Borgo 9.7:1 LM pistons as supplied by the factory .Anyone know what alloy they are and what bore clearance they should run ? I have found a very nice set of std liners and may be able to hone them and use them with the pistons . The data that Artevonne (Paul ) has posted on the LM motor notes that the bores were 0.03/0.04mm bigger than std ? Any ideas ?
     

Share This Page