430 - Front Splitter Separated | FerrariChat

430 Front Splitter Separated

Discussion in '360/430' started by jerbear27, Oct 28, 2023.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. jerbear27

    jerbear27 Formula Junior Silver Subscribed

    Joined:
    Jun 12, 2022
    Messages:
    300
    Location:
    CT
    Full Name:
    Jeremy
    Nice 80 degree day here up in New England. Took the car out for a bit. At one point during the drive, I hear some banging and then look out to see something flying in the air behind the car. Pulled over a few miles later and looked around and didn’t see anything obvious. Then around the front of the car I saw something hanging off the front splitter. Turns out, the front splitter separated and the lower part separated from the top part and flew out under the car. Anyone ever had this happen or heard of it happening before?




    Image Unavailable, Please Login
     
  2. CoreyNJ

    CoreyNJ Formula 3 Silver Subscribed

    Joined:
    Apr 17, 2006
    Messages:
    2,476
    Location:
    New Jersey Shore
    Are you saying the center piece that bolts onto the bottom of your bumper came apart and the bottom piece flew down the road? Sounds like an opportunity to replace with a carbon version. But seriously is that way happened?
     
  3. jerbear27

    jerbear27 Formula Junior Silver Subscribed

    Joined:
    Jun 12, 2022
    Messages:
    300
    Location:
    CT
    Full Name:
    Jeremy
    Exactly what happened. And more than likely the route I’ll go.
     
  4. CAV 430

    CAV 430 Rookie

    Joined:
    May 23, 2020
    Messages:
    1
    Location:
    Australia
    Full Name:
    Paul Taylor
    Yup, same thing happened to me, ran over it took me a while to figure it out!
     
  5. mwstewart

    mwstewart F1 Rookie

    Joined:
    Feb 5, 2014
    Messages:
    2,782
    That green epoxy that Ferrari use is generally pretty good, but it isn't infallible: I've had some areas of failure on my Spider hood cover near the engine lid. Replaced with a one-off carbon part.
     
    jerbear27 likes this.

Share This Page