Buy

Gearbox filter (182100)

Discussion in '360/430' started by AmoCS, May 4, 2013.

  1. Keith360

    Keith360 Formula Junior

    Feb 6, 2015
    545
    Santa Barbara County
    Full Name:
    Keith Williams
    Thinking of drilling the hole, but also thinking of making an aluminum cover plate with three countersunk holes 120 degrees apart. Like an aircraft inspection cover.
     
  2. To remove this ad click here.

  3. RSR993

    RSR993 Rookie

    Jul 6, 2019
    13
    Full Name:
    Jay J
    Is this filter re-usable?
     
  4. Skippr1999

    Skippr1999 F1 Rookie
    Silver Subscribed

    Dec 22, 2009
    3,198
    Yes. It’s metal
     
  5. John_K_348

    John_K_348 F1 Rookie

    Sep 20, 2013
    2,702
    Boston, MA
    Full Name:
    John E. Kenney
    Follow up...

    What is the diameter of the screen flange including the ear? 35mm or is it slightly larger, like 37-39mm? If so, a nice 1.25 inch grommet will fit from a grommet kit available on Amazon and 1.25 inch hole saws are common too. I am ready to do this mod along with my fluid changes this summer. Just got my baby back from FoNE after losing the F1 pump during a charity event last month. Sure I could have done the DIY route, but with a 400 mile tow and not sure a bleed was required on a weekend was too much. So I have a new motor, pump, and get this...uprated 50A fuse from Ferrari plus the 2 yr warranty, along with my healthy CS TCU from Europe. I just made a heat shield and heat sink for the pump motor and panel, and will post a thread on this later.
     
  6. clean512

    clean512 Formula Junior
    Silver Subscribed

    Feb 4, 2010
    662
    Nor Cal
  7. To remove this ad click here.

  8. John_K_348

    John_K_348 F1 Rookie

    Sep 20, 2013
    2,702
    Boston, MA
    Full Name:
    John E. Kenney
    Nice. You could even clean it up a little more with some black touch up paint and fasteners. You know, maybe even adding some louvers would be good because it seems we can't get enough ventilation with these modern under trays and diffusers. I've left all my grommets out underneath and plan to make one for my new drill project, but it will be much smaller than this and I'm looking to conceal it. Oh, and what did your filter look like? Was it bad?
     

Share This Page