GT4 door panel removal? | FerrariChat
Buy

GT4 door panel removal?

Discussion in '308/328' started by Perfusion, Jun 16, 2006.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Perfusion

    Perfusion F1 Rookie

    Oct 16, 2004
    4,151
    Marietta, GA
    Full Name:
    Aaron
    #1 Perfusion, Jun 16, 2006
    I decided that I wanted to take my door panel off today on the GT4. I unscrewed the interior door latch, the lock post, popped the light out of the door, removed all the screws around the perimeter (including the 3 on the bottom and the 2 large flathead screws on the actual metal door that faces the jam), and the bugger is still *really* holding on well! What did I miss? With the door open, the bottom right corner (driver's side door, BTW) is loose and can be pulled away. The top and left-center portions around the perimeter are still really snug, though, and on a 27 year old car, I don't want to force anything and end up breaking it.

    Thanks!

    Aaron
     
  2. jm3

    jm3 F1 Rookie

    Oct 3, 2002
    4,364
    United States
    Full Name:
    JM3
    #2 jm3, Jun 16, 2006
    There is a one more screw behind the top of the armrest/door pull, right above where you put your hand to pull the door shut. Make sure you disconnect the battery. Those interior lights are hot+12 even with the key off.

    Jay
     
  3. Perfusion

    Perfusion F1 Rookie

    Oct 16, 2004
    4,151
    Marietta, GA
    Full Name:
    Aaron
    #3 Perfusion, Jun 16, 2006
    I definitely missed that one... Thanks! Battery is disconnected, too, but good reminder. <thumbs up>

    Best regards!
    Aaron
     

Share This Page