Heat Shields Location?

Several weeks ago I started on the 360 A/C that was not working. Found that the clutch was bad and blowing fuses. The compressor was leaking a little oil so I sent the compressor off to be rebuilt. Since it was down and at least two weeks turnaround, the throw out bearing was making a little noise, so I pulled the transmission and replaced it. It was time for a belt service so I threw that in as well. The headliner fabric fell down so I figured it was a good time to remove the foam and replace it. I have had this car for 15 years and have never had anything other than the belt services on it along with the heat exchanger that is a common failure.

I have finished the throw out bearing and the transmission is back in. The headliner is finished and I just need to glue it in place and replace the trim. I am waiting on the tool to lock the clutch so I can remove the main pulley bolt but everything is open and ready for the belts. The Hill tool is on backorder. Everything has been easy so far.

The only issue I now have is where do these shields go? I cant remember for the life of me! It sucks getting old and the Ferrari diagrams don't show the location. Can anyone send me a photo as I cant seem to find where they mounted?

 

Forgot the photo of the shields