HELP ! Oil filter removal advice | FerrariChat
Buy

HELP ! Oil filter removal advice

Discussion in '360/430' started by phildb4, Nov 26, 2009.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. phildb4

    phildb4 Rookie

    Apr 6, 2009
    5
    #1 phildb4, Nov 26, 2009
    After reading many great threads on oil change, I decided to DIY. All is OK until it comes to removing the filter (2005 360 Spyder F1). Using the recomended oil filter wrench, I could not budge it, even with a 20 inch breaker bar. Should I try an impact wrench to break it loose? Other suggestions?? I am assuming the last "tech" overtightened, or am I missing something?
     
  2. swilliams

    swilliams Formula 3

    Jun 14, 2006
    1,407
    Bowling Green, KY
    Full Name:
    Scott
    #2 swilliams, Nov 26, 2009
    Last edited: Nov 26, 2009
    what are U using to take it off?

    I use the Hill Oil filter tool, an 8" or so 1/2 inch extension and a Torque wrench (mine is like most around 24-30" long)

    Ive never had a problem and have tons of leverage. I would not use an impact gun if it is stuck it will cause a bigger problem and mess. ( I could see it spinning the tool on the filter)

    If you didn't drain the oil yet let the engine warm and the heat may help it break loose.


    BTW, you are turning it counter clockwise correct??? ;)
     
  3. phildb4

    phildb4 Rookie

    Apr 6, 2009
    5
    #3 phildb4, Nov 27, 2009
    Thanks for the advice. Was using the correct tool, and knew using an impact gun was not a good idea (just wanted a 2nd opinion) Tried it again, after having Thanksgiving turkey, and it came right off. (let's not draw any conclusions)
     
  4. chrmer3

    chrmer3 Formula 3

    May 19, 2006
    1,719
    USSA
    Full Name:
    Chris
    #4 chrmer3, Nov 27, 2009
    Big meal eh? ;)
     

Share This Page