Hi all, I just ordered a set of test pipes and a super sport exhaust from Nouvalari. Thanks Glenn for your help so far. I'm going to do the install myself. I have a 4 post lift and a good set of tools. What would be the procedure? I did a search but in the thread I found, someone sent a PM to the OP. A PM or a reply is ok with me. Fyi, I am going from a stock system to this... Thanks in advance! Image Unavailable, Please Login
I would give you the link to my instructions, but they are for removing the dual can mufflers from a 348. However. Here is your opportunity to take pictures of your removal, and post up the instructions for the next guy.
Straight forward. I am running that exact same setup. Took me less than two hours. Just jack up the rear and start disconnecting... Kai
This is not a difficult job whatsoever. Like Ernie said, turn this into a "how to" for future reference
Expect to snap some of the original bolt heads if it's an original. When i did my 348 I replaced all the nuts and bolts with stainless plus bought all new olive gaskets
Remove the bumper as your first step and it will make all else so much the simpler. Depending on the mileage and weather conditions your car experienced, you may need some new bolts for the collector to cat and/or cat to muffler. Use new donuts. Use muffler paste for the O2 sensors and thermocouples. Remember you do not need to honk down the fastners, just make them snug enough to not leak exhaust. Do not tighten everything until you have it all pieced together because you may have to adjust angles and such.
To the OP, PM me if you still need instructions on how to do this. I have done this at least half a dozen times that sometimes I don't think about it anymore. I can write more detailed instructions but need more down time to do that. cheers
