hydraulic wheel rollers/dollies | FerrariChat

hydraulic wheel rollers/dollies

Discussion in 'Technical Q&A' started by Yoric, Jan 12, 2008.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Yoric

    Yoric Formula Junior
    Rossa Subscribed

    Jan 8, 2005
    383
    Full Name:
    Yoric
    I'm shopping for a set of hydraulic self-jacking wheel rollers to move my cars around the garage. Griot's has some, but at $600 for a set of four (plus $50 shipping), I wonder if there are any alternative sources out there for these hydraulic casters. I'd also be curious if anyone has purchased or used these dollies and what the usage/experience has been like.

    muchas gracias
    ricardo
     
  2. rtking

    rtking Formula Junior

    Mar 5, 2006
    703
    Huntington Beach, CA
    Full Name:
    Bob King
    Not hydraulic, but there are car movers/casters from Harbor Freight. You'd have to jack-up the car yourself and put these casters underneath each tire. Works well as long as you have a hard surface (concrete) in your garage. I have Race Deck (plastic) tiles and they make it tougher to move the car.

    http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=32052
     
  3. kens

    kens Formula 3
    Silver Subscribed

    Jun 25, 2006
    1,336
  4. davehelms

    davehelms F1 Rookie

    Jan 3, 2004
    4,629
    Full Name:
    Dave Helms
    I have a set of the cheap ones where the car is set down on the pads. I bought them from a guy that had an Amphicar collection right near you. Worthless, wont even handle the weight of a 308 and move easily. Its all in the caster wheels. I dont remember the brand but the ones that are pink and purple with an open side and the hydraulic pump work wonderful even for a full sized car. The other upside is they have a poly coated wheel that would be tile friendly for your application. I priced the replacement wheels to upgrade the units I have and the cost is the same as buying the good hydraulic go jack units. My concern would be the weight / square inch the tile would be subjected to but I guess that would be under 250# per wheel even with the plastic cars.

    Before I would pay what they want for the hydraulic units I would seriously consider a non-anchored 4 post and stack vertically. Then again, there is some space behind the Panzer where one could wedge...... Hmmm, needing Go Jacks with the new garage implys there is a new addition in the works??

    I am taking advantage of the weather we have had and suggested to Kris "wouldnt it be nice to have a big old timber framed barn where we could have radiant heat panels in the ceiling of the center isle and you could brush down the horses out of the cold wind?" The suggestion was made when our female Farrier was here and the wind was blowing cold out of the north. SCORED! Timing is everything. The right suggestion at the right time in the right company........


    Dave
     
  5. 330gt

    330gt Formula 3

    Nov 12, 2004
    2,096
    Seattle, WA
    Full Name:
    Kerry Chesbro
    I have a set of the Griot's. I got them at their annual garage sale at their headquarters, so only paid ~180 for the set of 4.

    They aren't hydraulic, but a lever/spring/pawl arrangement to hold the tire off the floor. They work quite well and one can easily move a car around on a level concrete floor.

    BTW, these are made by GOJACK for Griot's.
     
  6. Meister

    Meister F1 Veteran
    Silver Subscribed

    Apr 27, 2001
    5,516
    Duluth, MN
    Full Name:
    The Meister
    I've got pretty much the exact same ones...work pretty well for the 308/Esprit.

    Something with coated wheels would be better/safe if you have a finished floor.

    The extra time/effort needed to to use a jack is minimal if you don't need to get the car on/off the dollies often.
     

Share This Page