I bricked my 360..

I was trying to adjust my clutch settings yesterday using my ThinkDiag which works half the time. Anyway I hit the bleed actuator by accident then tried to stop it because it was making wierd noises. Now it won't start, the F1 will not come on. Scanner shows no errors or codes but it only sees the Bosch right bank in recovery no regular. See screenshot. Wonder if it blew a fuse or relay

 

Just turn off the kill switch for a while?

 

@flash32 thanks for the advice - that did bring the F1 pump to life. Now that it is, it kicked a whole bunch of codes! I can't believe what I did caused all this. I tried just clearing codes but that didn't work! Do you know anything about this? There were no codes until yesterday so stopping the F1 bleed caused all this. ALSO - instead of neutral showing on the display it flashes an "S"

Inspection Result
Right Bank Motronic Bosch Engine Management System 7.3.1 - Recovery 2
1.020d1741 Please Refer To Manual!
2.020d1742 Please Refer To Manual!
Left Bank Motronic Bosch Engine Management System 7.3.1 - Recovery 2
1.020e1741 Please Refer To Manual!
2.020e1742 Please Refer To Manual!
Semi-Auto GearBox CFC201 - First Version 2 problems exist
1.P1741 Engagement Potentiometer
2.P1742 Selection Potentiometer
Semi-Auto GearBox CFC201 - Second Version 2 problems exist
1.P1741 Engagement Potentiometer
2.P1742 Selection Potentiometer
Marelli Semi Automatic Gearbox System CFC231 2 problems exist
1.P1741 Engagement Potentiometer
2.P1742 Selection Potentiometer