News

I have issues on my car FF 2014 low 4wd atf oil pressure

Discussion in 'FF/Lusso/F12/812S' started by Ibrahim ff, Jun 4, 2020.

  1. Ibrahim ff

    Ibrahim ff Rookie

    Jun 4, 2020
    1
    Full Name:
    Ibrahim
    Did any of you guys happen to know how to fix this problem? Some said to change the battery it might work but unfortunately, it did not, I have no warranty so going to the dealership is not a choice.
    I will upload the videos and if you have any recommendations please let me know.
    Thank in advance
     
  2. To remove this ad click here.

  3. Georgemaser

    Georgemaser Karting
    Silver Subscribed

    Aug 7, 2014
    196
    Michigan
    I had that same thing with my Lusso in the winter after just getting it. I put it on the battery trickle charger for a couple days and I have only seen it once since but it went away after I restarted it.
    Good luck!
     
  4. Elasto

    Elasto Karting

    Aug 27, 2014
    105
    Vienna, AUSTRIA
    Full Name:
    Andreas
    If only the ptu had a problem, why does the car show manettino and e-diff failure?
    I've had this alerts too (FF), they are known Italian electrical "issues".
    Charge the battery and try it again.
     
  5. ttforcefed

    ttforcefed F1 World Champ
    Rossa Subscribed

    Aug 22, 2002
    15,774
    it might not be PTU - cld just be 3rd gear sensor. where are you locate?
     
  6. To remove this ad click here.

  7. otakki

    otakki Formula 3

    Mar 24, 2016
    1,532
    I think I have seen the 4WD system failure message a few times before. It went away after restarting. I don't think I have seen it again after changing to an Interstate battery.
     
  8. ttforcefed

    ttforcefed F1 World Champ
    Rossa Subscribed

    Aug 22, 2002
    15,774
    yeh i have gotten that error since new lol
     
    otakki likes this.
  9. Darkshear

    Darkshear Karting
    Silver Subscribed

    Mar 31, 2019
    76
    Tampa, FL
    Full Name:
    Kalon Dillon
    Do you have anything plugged in to the OBD II port? If so, remove whatever it is, leave the car for a few minutes and try again. Ran in to this with my dash cam--the OBD II transmitter for telemetry caused the computer to go in to diagnostic state and the full series of failure messages scrolled like yours.
     

Share This Page