Indor lock switch not functioning on 430 | FerrariChat
Buy

Indor lock switch not functioning on 430

Discussion in 'Technical Q&A' started by Chocorem, Nov 22, 2014.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Chocorem

    Chocorem Rookie

    Nov 10, 2014
    39
    #1 Chocorem, Nov 22, 2014
    Hello,

    I just bought a 430 and find out the both lock switches and not functioning...


    Door are closing well with the remote !

    So before dismantling the whole door panel to check the switches, is there something else to check ?

    I was wondering because it is weird that both sides ares not working !


    Sent from my iPad using tapatalk
     
  2. Tally Ho

    Tally Ho Formula Junior

    Jul 4, 2007
    720
    Niceville, FL
    Full Name:
    Bill
    #2 Tally Ho, Nov 22, 2014
    I have the same issue with my 430. I can lock the doors with the key either manually by inserting in the door key hole or by pushing the button in the key. The inside switches do nothing.
     
  3. 24000rpm

    24000rpm F1 Rookie

    Aug 31, 2012
    4,653
    China and California
    #3 24000rpm, Nov 22, 2014
    can you lock the door using the fob while the engine is idling and nobody's in the car(doors shut)?
     
  4. Chocorem

    Chocorem Rookie

    Nov 10, 2014
    39
    #4 Chocorem, Nov 23, 2014
    When the motor is running, the button of the key has no action !


    Envoyé de mon iPhone en utilisant Tapatalk
     
  5. synchro

    synchro F1 Veteran

    Feb 14, 2005
    9,294
    CHNDLR
    Full Name:
    Scott
    #5 synchro, Nov 27, 2014
    I would start the investigation in this order;
    The fuse, grounds, the relay, the switch, and wiring
     
  6. Sled Driver

    Sled Driver Formula Junior

    May 13, 2010
    494
    Stokesdale, NC
    Full Name:
    Emery
    #6 Sled Driver, Nov 27, 2014
    Well, since the remote locks & unlocks the door it has nothing to do with the fuse, grounds or relay..................


    I would focus on the lock linkage (rods) in the doors & then the door latches where the lock linkage attaches.

    If one of the rods is misadjusted it will affect both doors. One of your doors interior locks may not be physically moving far enough to engage the lock solenoid.


    Recently my passenger's side interior lock lever would not lock the doors. The driver's side worked normal & locked both doors.


    What I found was excessive play where the rod end attached to the lever in the interior door handle. I put a bushing in the lever & readjusted the rod.

    The length of the rod sets the angle & total travel of the interior door lever. You adjust it so when the door locks the lever flush with the handle.
     
  7. vrsurgeon

    vrsurgeon F1 World Champ
    Silver Subscribed

    Dec 13, 2009
    16,589
    Charleston, SC
    Full Name:
    Curt
    #7 vrsurgeon, Nov 27, 2014
    +1
     

Share This Page