Interior Rubber buttons etc sticky | FerrariChat
Buy

Interior Rubber buttons etc sticky

Discussion in 'California(Portofino)/Roma(Amalfi)' started by Nautilus1, Jun 27, 2021.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Nautilus1

    Nautilus1 Karting

    Apr 24, 2011
    224
    NYC
    #1 Nautilus1, Jun 27, 2021
    I have. 2014 California T where the rubber buttons and shades over the driving gauges have ALL become sticky. Is there a way to fix this or should it all be replaced, if it needs to be replaced how much would that run and is it very difficult? I know this is a common design flaw in al, ferraris and it’s the one thing I wish they would finally friggin fix as I had this on my original Ferrari California as well.
     
  2. davidtopp

    davidtopp Karting

    Jun 7, 2019
    82
    UAE
    Full Name:
    David Topp
    #2 davidtopp, Jun 27, 2021
    Look up Sticky RX. I did my buttons and binnacle shade this year. They were a gooey mess and came back better than new. Expensive but worth it if you plan to keep the car. Worst bit was pulling the dash to bits to get all of the buttons out in the first place.
     
    whatheheck likes this.
  3. Bill Phillips

    Bill Phillips Formula Junior

    Nov 4, 2019
    480
    New Orleans
    Full Name:
    Bill
    #3 Bill Phillips, Jun 28, 2021
    StickyRx is definitely the way to go. Replacing all the sticky bits just kicks the can down the road - it'll happen again. And their resurfaced parts are much nicer than the originals. The only drawback is that you'll be without those parts for several weeks or so.
     
    whatheheck likes this.

Share This Page