Is there a 2nd fuse inline for mondial t window motors?

Hi All,
So I have 91 Mondial T had both my door panels apart to install new speakers.
Before and while working both window motors worked as usual. Not fast but steady. After I put all the kit back
My passenger side window wont move. I know it is somewhere between the switches because
1st I swapped switches with Driver side and they both work. Then I jumped the
window direct 12v and it went up and down really slick. Wish it would do that all the time.

I read on a 348 thread that there is 2 fuses on the 348 is there a second fuse for Mondial T?
There was a 20amp fuse that was blown that i replced but that happened when I was testing
continuity and voltage. I know its not the gears or motor. I did not see a Relay fuse for windows
Thanks for you help.

crash

 

On the 348 there is a twist off connector in the door jam, between the hinges. I don't know if it's the same on a Mondial but if it is, you may wanna have a look because the wires do have a tendency to break underneath the rubber boot, on the back side of the pins.

 

Thanks,
I will take a look. I think I traced it and it does go back through the door where
the speaker wires goes, but have no idea where the wire connects next? Maybe behind the
foot well.

 

So I've jumped it and it still goes up and down, but now the switch on
The passenger side will make it go up but not down.
I also checked voltage on the up switch pin and the down
Switch pin and they seem to be sending some voltage regardless of
Up or down. The working driver side does not pass voltage only
In the direction of the window.

 

So the motor is getting 12v from the switch to
Lower the window, yellow/Blk wire. But at the same
Time it is passing 12v back down the blue/Blk wire.
This should be ground. Does this mean my
Motor is shot because it is not switching to ground?

Thanks for the help