License Plate Bolt Size? | FerrariChat
Buy

License Plate Bolt Size?

Discussion in '348/355' started by surfwolf, Nov 27, 2012.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. surfwolf

    surfwolf Formula 3
    Silver Subscribed

    Oct 14, 2012
    1,698
    Bethany, OR
    Full Name:
    Michael Wolfe
    #1 surfwolf, Nov 27, 2012
    I have a 1995 Ferrari 348 Spider that I finally have plates for (Law Enforcement Will Use Anything to pull you over in a Ferrari!). I need to install the rear plate onto the factory mounts. Any idea what size bolts I need? Probably lots of aftermarket bling ones, but I just want high quality stainless steel versions.
    Thanks,
    Mike
     
  2. bosshog8

    bosshog8 Formula Junior

    Mar 13, 2011
    448
    Pinelands NJ
    Full Name:
    Demetrius
    #2 bosshog8, Nov 27, 2012
    It's a screw thread not a machine thread. In standard measure maybe an 8 or 10. I have no idea what that is in metric.
     
  3. surfwolf

    surfwolf Formula 3
    Silver Subscribed

    Oct 14, 2012
    1,698
    Bethany, OR
    Full Name:
    Michael Wolfe
    #3 surfwolf, Nov 28, 2012
    I found metric license plate screws (stainless steel) at: belmetric.com
    They have multiple length & width screws that are specifically listed as license plate screws, most are approximately $0.20 a piece. mine are ordered & on the way
     

Share This Page