LINGERIE ~ 550 SPEED BRA Installation | FerrariChat
Buy

LINGERIE ~ 550 SPEED BRA Installation

Discussion in '456/550/575' started by giade, Sep 15, 2011.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. giade

    giade Rookie

    Dec 19, 2004
    22
    NEW MEXICO USA
    #1 giade, Sep 15, 2011
    Do those things even go ON? SeemS RRReally TighT! even after Basking in the SUN all day... And havent Seen HOW to Mount those Brackets that have to Fit INside the front Wheel Wells... Actually i dont even know How to Raise the Wheels off the Ground...WHERE does a Jack Fit, with that AERO PAN under there...would NOT want to Bend some Steering/Suspension component lifting the Car in the wrong place..
     
  2. darth550

    darth550 Six Time F1 World Champ
    Lifetime Rossa

    Jul 14, 2003
    61,136
    In front of you
    Full Name:
    BCHC
    #2 darth550, Sep 15, 2011
    Use a hair dryer to get it hotter....

    The inside fender well cover has to come out and it bolts in along the front edge.
     
  3. Texas Forever

    Texas Forever Eight Time F1 World Champ
    BANNED Rossa Subscribed

    Apr 28, 2003
    85,600
    Texas!
    #3 Texas Forever, Sep 15, 2011
    I went your way about eight years ago, with Speed Lingerie no less.

    1. I ended up paying the dealer to do the job.

    2. I ended up having to cut out the mesh because it was causing the car to overheat. I ain't kidding.

    3. I would have been MUCH better off if I had gone with plastic.

    Dale
     
  4. darth550

    darth550 Six Time F1 World Champ
    Lifetime Rossa

    Jul 14, 2003
    61,136
    In front of you
    Full Name:
    BCHC
    #4 darth550, Sep 16, 2011
    Yup, I had to as well, in fact, the later SL versions had big cut out circles cut in the mesh.
     
  5. alberto

    alberto Formula 3

    Aug 25, 2001
    2,404
    San Diego
    Full Name:
    Alberto
    #5 alberto, Sep 16, 2011
    Last edited: Sep 16, 2011
    I paid a boat load for a new speed lingerie car bra. That was a mistake. They claim that it will not flap at speed, not true at all. Since it was for a 328, well known to scrape the front on anything over 1/4 inches high ( :) ), the bottom of the bra also tore. Save your money, either put clear plastic on it or nothing at all and just spray is every few years.

    To add insult to injury the bozos as speed lingerie were absolutely uncooperative and unwilling to address the issue. I sent it to them, they measured it to make sure it was correctly made, they said it was but that they would not refund my money. So, tough ****.

    But, to answer your question, yes it is a very tight fit. I had to struggle to get it on, but eventually, regretfully, I managed.


    Alberto
     

Share This Page