Long term Fabspeed header experience | FerrariChat
Buy

Long term Fabspeed header experience

Discussion in '348/355' started by Monteman, Feb 15, 2010.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Monteman

    Monteman Formula 3
    Rossa Subscribed

    Feb 9, 2006
    2,348
    Santa Barbara, CA
    Full Name:
    Monte
    #1 Monteman, Feb 15, 2010
    I'm just getting ready to place an order for a set of Fabspeed headers for my 355 and wanted to check my trusted friends here on FChat to see if anyone has had any issues or recommendations with them now that they've been on your cars for 1+ years. BTW, I'm planning on getting them coated so no need to recommend that.
     
  2. Vegas-Guy

    Vegas-Guy Formula 3

    Nov 25, 2007
    1,828
    Austin, TX
    Full Name:
    Reg
    #2 Vegas-Guy, Feb 15, 2010
    I've had mine on for 1 year 8mo. and about 10k miles with NO problems, but I also put on Hyper-flow cats at the same time...:) Mine are also coated inside and out.

    Reg
     
  3. mesoscale

    mesoscale Formula Junior

    Feb 19, 2004
    305
    #3 mesoscale, Feb 15, 2010
  4. BrandSB

    BrandSB Karting

    Jun 11, 2008
    236
    Canton, Michigan
    Full Name:
    Steve
    #4 BrandSB, Feb 19, 2010
    Last edited by a moderator: Sep 7, 2017
    I'm in the middle of the installation process and so far so good for fitment. I plan to write a brief DIY summary when complete. Are you DIY or having someone install them for you? I just installed the driver's side system this week. Makes my engine look dirty (it is :)).
    Image Unavailable, Please Login
     
  5. UConn Husky

    UConn Husky F1 Rookie

    Nov 11, 2006
    4,425
    CT
    Full Name:
    Jay
    #5 UConn Husky, Feb 19, 2010
    Nice work Steve!

    Zero probs with mine, and they still look great with the ceramic coating.
     
  6. ferrari 512 tr

    ferrari 512 tr F1 Rookie

    Nov 16, 2008
    4,180
    Australia
    Full Name:
    Paolo
    #6 ferrari 512 tr, Feb 19, 2010
    those extractors look beautiful
     
  7. Alex@fabspeed

    Alex@fabspeed Formula Junior

    Dec 6, 2006
    401
    Fort Washington, PA
    #7 Alex@fabspeed, Feb 19, 2010
    Lookin' good Steve : )
     
  8. BrandSB

    BrandSB Karting

    Jun 11, 2008
    236
    Canton, Michigan
    Full Name:
    Steve
    #8 BrandSB, Feb 19, 2010
    Thanks for the feedback, this is a fun project (not like your engine out Jay, but hey, gotta start somewhere right??). However, advance warning, the left and right sides are Dr. Jekyll and Mr. Hyde as far as getting the OE headers off. I'll elaborate at the end when it's done so as not to jinx the project...
     

Share This Page