Need diagram | FerrariChat
Buy

Need diagram

Discussion in '308/328' started by jrairplane, Oct 18, 2009.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. jrairplane

    jrairplane Rookie

    Aug 13, 2009
    10
    #1 jrairplane, Oct 18, 2009
    Just finishing my clutch replacement and I need a diagram showing the O ring placement on the transmission input shaft. There is a collar that I believe holds the O ring (it fell out when I pulled the bell housing off and I did not see which way it fit on the shaft). I've tried search but to no avail. Thanks.
     
  2. ramosel

    ramosel Formula 3

    Sep 11, 2004
    1,237
    Meadow Vista, CA
    Full Name:
    R Moseley
    #2 ramosel, Oct 18, 2009
  3. rizzo308

    rizzo308 F1 Rookie
    Silver Subscribed

    Sep 12, 2004
    2,780
    Perth, Australia
    Full Name:
    riggio
    #3 rizzo308, Oct 18, 2009
    Last edited by a moderator: Sep 7, 2017
    the collar you are talking about locator/stop for the bearing .... sometimes these end up in the little pocket in bottom of the cover as you slide it off ...... there should be 3 oring seals... the seal on the g/box shaft slap a small amount of silocone on it 9 times out of ten the seal becomes dislodged against the shaft of as you slide the cover back on just before the cover is hard up agianst the engine chek the seal is in place and seated properly
    Image Unavailable, Please Login
     

Share This Page