Need new ideas

OK, while trying to replace the accelerator cable I found that if I feed it into the tube inside the car it goes in about 1.5 metres and then hits a turn in the tube and stops.

Equally if I put it in the tube in the engine bay it goes about 1.5 metres and hits a kink in the tube inside the car and stops.

I put a 3mm x 4M piece of wire in the tube and without the outer casing it went from the engine to the end of the tube inside the car , great , so now I try it from inside to the engine and it stops about 30cm from the end of the tube.

So I put some tape around the new cable and the feeder wire to pull it through the tube

Well the wire pulled out of the tape as it was feeding through the tube and when I pulled the new cable out the tape came off about 50-70mm from the end of the tube

Now I can't get the feeder wire through the tube so I tried putting super glue on the end of the feeder wire and pushed it into the tape inside the tube, waited for it to set hard and pulled the feeder wire out slowly but it didn't work.

I'm thinking of heating the feeder wire up and pushing it into the trapped tape

Any other ideas , and don't say call Marc because he's never done this

Here's a picture of the tube which is at the firewall in behind all of the piping

I'm thinking fire but that will just melt the tape (electrical insulation tape) and make things worse

Image Unavailable, Please Login

 

Too hard to get near the tube but thanks

Thanks Ian, I got the same silicone spray idea from the dealer and he said compressed air.

The fencing wire is what I was calling "feeder cable" and from the inside of the car I can push this wire to within a foot of the exit of the tube in the engine bay, seems to be hitting a ridge or something and this ridge is about 6-9"from the tape blocking the tube.

The feeder cable went all of the way through when feeding it in from the engine end, which was why I stupidly taped the new cable to it and had Neralee pulling from inside and I pushed from the engine end .... we got out of sync and the wire pulled out of the tape and then when I pulled the new cable out the tape came off in the tube

I knew you'd have some good ideas

CLINT

Yeah, that's my new cable, just won't got through the tube, gets caught a foot from either end

 

I read all the crap in the 355 section, didn't help

I now know that I need a a nut that I can screw the old and new cable to and pull it through

Hindsight is always easy

 

Good idea Gaz, I'm actually looking for a small metal ball, drill a hole and silver solder then it won't get caught but your idea has merit, I'll give it a try .... after Steve ratifies it

 

Great idea but I think it's damn weird that I can push the 3mm wire from the engine to the pedal but not from the pedal to the engine bay .... .and also that I can push the new cable from the engine bay to within a foot of the pedal or from the pedal to within a foot of the engine bay

Once I get this damn tape out I'll have it fixed in no time

 

Yes, the dealer had the same idea and that combined with Ian's silicone spray should do it but I'm buggered from laying over the top of the engine all day

I also bought a blowtorch to heat up the wire ........ I'll try anything at this stage

But thanks everyone for the ideas