Oil change this weekend, should I do anything else?? | FerrariChat

Oil change this weekend, should I do anything else??

Discussion in '348/355' started by Gab, Apr 17, 2013.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Gab

    Gab Rookie

    Jun 19, 2010
    33
    Vancouver, Canada
    Full Name:
    Gab
    Hi guys,

    as the title states I'm planning to change the oil this week end and I have ordered the Ricambi kit. There is a ton of info here and I feel pretty confident that it'll be pretty easy. The only thing that I'm really wondering is if there is anything else I need to look at changing? Air filter, or any other fluids that should be changed yearly.

    The car had its major done about 2 years ago and has been regualary serviced by the local dealership, but I thought I'd start to do a little work myself so I can fully enjoy the Ferrari experience. I had a CEL that came on late last year and it was diagnosed as O2 sensors failing. I have already replaced all 4 myself which was fun, and a lot cheaper than the dealership quoted. The car has no other problems and drives beautifully.

    Any help or insight is welcome. Thanks
     
  2. Subarubrat

    Subarubrat Formula 3

    Apr 1, 2009
    2,072
    VA
    Full Name:
    Scott
    I am doing mine this month, here is what I do each year, excessive perhaps, but also cheap insurance and corrosion prevention.

    engine oil/filter
    trans fluid
    F1 fluid
    power steering fluid
    brake fluid
    clean/oil air filters
    coolant
     
  3. drftfan

    drftfan Formula Junior

    Jan 12, 2011
    357
    Orange County
    Full Name:
    Jamie
    Yes do the trans fluid. I should have but when I found my ripped cv boot that became more important.
     
  4. ketel

    ketel Formula 3

    Aug 6, 2007
    1,355
    Sausalito, CA
    Hey, I have a CEL also and suspect it is the 02 sensors. I want to replace these myself.

    How did you do it? What resources did you consult? Any DIY vids or other guidance you can provide?

    Thanks,

    ketel
     
  5. Subarubrat

    Subarubrat Formula 3

    Apr 1, 2009
    2,072
    VA
    Full Name:
    Scott
    Undo the plug, unscrew the old one (7/8 in wrench). Put a bit of anti-seize on the threads of the new one and screw it into place and plug it in, not much to it.
     
  6. Gab

    Gab Rookie

    Jun 19, 2010
    33
    Vancouver, Canada
    Full Name:
    Gab
    I searched for a "how to" on this and couldn't find anything. It is really easy, and no one should have to pay to get this done. You will need ramps, wrench and some zip ties.
    Here is what I did:

    1. Raise the rear by backing up on ramps.
    2. Turn the battery off (switch is in the trunk passenger side)
    3. Locate O2 plugs in engine compartment and trace wire down to sensor in exhaust. I had my brother wiggle the wires while I was under the car.
    4. Unplug sensor and remove corresponding sensor. They are screwed before and after the Cats and are pretty tough to get out but with some effort I managed to get them unscrewed. Not trick just effort.
    5. Check the model number of the old sensor to the new to make sure they match. There are 2 types of O2 sensors pre Cat and post Cat. Don't mix them up.
    6. Pass wires back up through engine bay.
    7. Zip tie wires and plug in.
    8. Repeat 3 more times.

    I only had codes of 1 bank of sensors but changed all as I didn't want to have to do it again.

    Good luck.
     
  7. Gab

    Gab Rookie

    Jun 19, 2010
    33
    Vancouver, Canada
    Full Name:
    Gab
    Perfect thanks. I will follow you lead, I have no problems with being excessive. :)
     

Share This Page