News

Parts question

Discussion in 'MVPEurosports.com' started by Llenroc, Jun 3, 2006.

  1. Llenroc

    Llenroc F1 Rookie
    Rossa Subscribed Consultant

    Jun 9, 2004
    3,065
    Colorado
    Full Name:
    Vern
    Hi Kevin, At one time I thought you had said that you could make 355 2.7 headers in Iconal(sp) if you can what is the cost and can they be ceramic coated on the inside only. Also you have carbon door panels for 355s are they an easy bolt on ie; using factory mounting holes and are they a good quality looking product? I've seen some fairly cheap looking carbon pieces out there in the market place. Regards, Vern
     
  2. RossoCorsaItaly

    RossoCorsaItaly F1 Rookie
    Rossa Subscribed

    Jun 9, 2004
    4,176
    EU
    Full Name:
    Kevin
    Their calculating cost and wait time, will have an answer in roughly 6-8 hours.
     
  3. RossoCorsaItaly

    RossoCorsaItaly F1 Rookie
    Rossa Subscribed

    Jun 9, 2004
    4,176
    EU
    Full Name:
    Kevin
    Vern,

    $8,850 roughly 4-6 weeks for 2.7 and they can be ceramic coated on the inside only.

    The carbon door panels I'm assuming you're speaking of the GruppeM?

    Regards,
    Kevin
     
  4. Llenroc

    Llenroc F1 Rookie
    Rossa Subscribed Consultant

    Jun 9, 2004
    3,065
    Colorado
    Full Name:
    Vern
    I don't know if they were GruppeM or not they are the ones on your web page. If they are GruppeM then I probably have anwered my own question on the quality thing. Regards, Vern
     
  5. RossoCorsaItaly

    RossoCorsaItaly F1 Rookie
    Rossa Subscribed

    Jun 9, 2004
    4,176
    EU
    Full Name:
    Kevin
    Only ones I currently have on my website are GruppeM. The quality I would assume like all other GruppeM is bar none. GruppeM replied to my email saying that they are a direct fit.

    Hope that answers everything.

    Regards,
    Kevin
     
  6. Llenroc

    Llenroc F1 Rookie
    Rossa Subscribed Consultant

    Jun 9, 2004
    3,065
    Colorado
    Full Name:
    Vern
    Thanks Kevin for taking the time appreciated as always. I will get back to you on both of those as I do what to do them. Regards, Vern
     

Share This Page