Power steering fittings | FerrariChat
Buy

Power steering fittings

Discussion in 'Technical Q&A' started by stevehuck, Jan 23, 2005.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. stevehuck

    stevehuck Formula Junior

    Jun 4, 2004
    331
    Sterling Hgts, Mi
    Full Name:
    Steven Huck
    #1 stevehuck, Jan 23, 2005
    Last edited by a moderator: Sep 7, 2017
    What do you call this type of fitting? I need seals for these fittings as well as others like fuel lines and such.

    I need 44,45,47,48

    media001.jpg[img/]
    [ATTACH=full]122988[/ATTACH]
     
  2. Gianluca

    Gianluca Formula Junior

    May 6, 2003
    349
    Centreville, Virgini
    Full Name:
    Gianluca Chegai
    #2 Gianluca, Jan 23, 2005
    Those are crush washers, usually made out of annealed alluminum or copper.
    They could be reannealed and reused but they should be cheap enough to just replace them.

    To reanneal, just gently heat them with a propane torch or over a gas stove (not too much heat) and quickly cool the in cold water. If you did it right, they will be VERY easy to bend.
     
  3. Darolls

    Darolls F1 Veteran
    BANNED

    Jul 2, 2003
    7,782
    Full Name:
    Sparky
    #3 Darolls, Jan 23, 2005
    They're called banjo fittings.

    You should be able to find the crush washers without much trouble.
     
  4. stevehuck

    stevehuck Formula Junior

    Jun 4, 2004
    331
    Sterling Hgts, Mi
    Full Name:
    Steven Huck
    #4 stevehuck, Jan 23, 2005
    Banjo Fittings!!!!

    Wow. Well i dont have the old ones to try to repair so i am going to look for some new.

    Thanks for the help.
     

Share This Page