Question about engaging reverse | FerrariChat
Buy

Question about engaging reverse

Discussion in 'Boxers/TR/M' started by kdross, Aug 10, 2015.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. kdross

    kdross Formula Junior
    Silver Subscribed

    Feb 10, 2002
    887
    NJ
    Full Name:
    Ken
    #1 kdross, Aug 10, 2015
    On my 308QV I had to push the gear lever down before I could move the gear lever into the reverse position and to engage reverse. On my 1985 TR, I can engage reverse by either simply moving the gear lever into the reverse position or by pushing down the gear lever and putting moving it into the reverse position. I would think I would not be able to engage reverse unless I push down the gear lever first and then move the gear lever into the reverse position. Any input on this issue? Just want to make sure my car is working 100%. Just had an engine out service and never drove the car before the service.

    Thanks,
    Ken
     
  2. Steve Magnusson

    Steve Magnusson Two Time F1 World Champ
    Lifetime Rossa

    Jan 11, 2001
    26,799
    30°30'40" N 97°35'41" W (Texas)
    Full Name:
    Steve Magnusson
    #2 Steve Magnusson, Aug 10, 2015
    Maybe possible issues:

    1. The "blocker" tab on the underside of the shift gate is worn, or the square section on the gear shift lever that contacts it is worn, or

    2. The gear shift lever is stuck in the down (or partially down) position.

    Have your ever inspected the underside of the shift gate?
     
  3. rpissm

    rpissm Formula 3

    Aug 11, 2013
    1,620
    Salt Lake City, UT
    Full Name:
    Joe
    #3 rpissm, Aug 10, 2015
    Yeah my 87 requires a push down before engaging reverse.

    Sent from my Nexus 10 using Tapatalk
     
  4. Melvok

    Melvok F1 World Champ
    Owner Silver Subscribed

    Jul 25, 2008
    14,263
    Amersfoort, The Netherlands, Europe.
    Full Name:
    Mel
    #4 Melvok, Aug 11, 2015
    This is NOT how it should be Ken ! Steve explains that also

    The safety cathch should allways be working to prevent .............. thousands of wasted dollars ...
     
  5. ozziindaus

    ozziindaus F1 Veteran

    Aug 16, 2012
    9,799
    Detroit
    Full Name:
    Sam
    #5 ozziindaus, Aug 11, 2015
    Same here and I only found out about it a few weeks ago. Remember how I used to complain about how hard reverse was? Well there you have it, I wasn't pushing down :confused:
     
  6. Ferrari Tech

    Ferrari Tech Formula 3

    Mar 5, 2010
    1,217
    Georgia
    Full Name:
    Wade Williams
    #6 Ferrari Tech, Aug 11, 2015
    The plate is probably installed backwards. Look and see if the "blocker tab" is in fifth gear position.
     

Share This Page