Rear license plate bracket | FerrariChat
Buy

Rear license plate bracket

Discussion in '348/355' started by Asta, Jun 15, 2015.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Asta

    Asta Karting

    Mar 29, 2014
    83
    NYC
    Full Name:
    Rob
    #1 Asta, Jun 15, 2015
    Upon removing the dealer plate I realized it was screwed directly to the bumper. There were two holes simply drilled into the fiberglass. Nor was there sufficient space for the bottom two holes on the plate, so the plate was held just by the top two holes.

    This seems rather ad hoc to me, and probably prone to rattle. Is this usual?

    I see that Ricambi sells a bracket, part no. 64497800, here: Ferrari F355 M5.2 (1996+) Parts : Table 126 - REAR BUMPER

    It seems that this bracket is affixed with plastic pop rivets then the plate is affixed to the bracket with four screws.

    Anyone have any experience with this?
     
  2. f355spider

    f355spider F1 World Champ
    Owner Rossa Subscribed

    May 29, 2001
    18,053
    USA
    #2 f355spider, Jun 17, 2015
    Mine was only attached at the top as well, directly into the bumper. As I recall there were nylon anchors in the bumper that the screws threaded into. No rattles, though I used a metal, black frame, that had two clips on the bottom to secure and support the license plate...that and the two top screws made sure it was rattle free.
     

Share This Page