Removing Rear Lid Marker on a 360 | FerrariChat
Buy

Removing Rear Lid Marker on a 360

Discussion in '360/430' started by slice, Sep 15, 2010.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. slice

    slice Formula Junior

    Jan 4, 2008
    312
    Connecticut, US
    #1 slice, Sep 15, 2010
    Apologies in advance if this is covered elsewhere, I've searched and cannot find a photo of the removal of the rear "Ferrari" marker. My shop gave me a few clips and everyone claims it is easy to "pop" them off from underneath, but with what? Also, are those two clips (on a 360 truck lid at least) the only thing holding it on, or am I going to knock said clips off only to find the thing still cemented on? Photos and real life experiences welcome.

    Thank you
     
  2. viperdrew

    viperdrew Rookie

    May 15, 2010
    9
    NJ
    Full Name:
    Drew Geffon
    #2 viperdrew, Sep 15, 2010
    The Ferreri emblem is affixed from underneath with these two clips, you can actually grab them with a long nose plyers and gently unscrew them. The emblem is also affixed with two sided tape, so it must also be gently worked loose. You can also try using some dental floss to work underneath the emblem from above to loosen the grip of the two sided tape, just watch the screw posts and be careful as the emblem is easily bent.
     
  3. ttdang123

    ttdang123 Formula Junior

    Nov 28, 2009
    706
    North San Diego CA
    Full Name:
    Tung
    #3 ttdang123, Sep 15, 2010
    On mine, the clips were pulled out but not screw out so they were basically destroyed in the process of removing. As long as you already got the spare clips (2 at least) then should be ok.

    To put the clips back on, use a small socket with the diameter slightly bigger that the clips to push them up - this will make the job much easier (push up slow and careful NOT TO DROP).

    Very easy job - just have to do it slow.
     
  4. slice

    slice Formula Junior

    Jan 4, 2008
    312
    Connecticut, US
    #4 slice, Sep 16, 2010
    Thank you for the replies...

    So it does have double sided tape...the next question then is: Will the double sided tape still have some level of "stickyness" left once I remove the marker and try to replace it?
     
  5. ttdang123

    ttdang123 Formula Junior

    Nov 28, 2009
    706
    North San Diego CA
    Full Name:
    Tung
    #5 ttdang123, Sep 16, 2010
    If you are careful and lucky enough then you might be able to reuse the double sided tape. Most likely it will be destroyed in the removal process as well.

    You can buy some very thin 3M double sided tape to replace it with.
     
  6. Kds

    Kds F1 World Champ

    May 1, 2003
    10,994
    Canada and Brasil...
    #6 Kds, Sep 16, 2010
    Fishing line also works for removing badges stuck on with 2 sided tape.
     

Share This Page