Replacing Rear Outer Tail-Light?

Does anyone know how to do this? How do you tighten or loosen the light? I don't understand how you even access the bolts???

I tried to glue it back on, but the surface areas that are glued are too small to support the weight of the light.

I posted on the 430 forum that I broke the light off merely by leaning against it. Here are the pics.
Image Unavailable, Please Login
Image Unavailable, Please Login
Image Unavailable, Please Login

 

Remove the right rear cover in the engine compartment.3 -4mm allens and 2 -3mm allens. You will then see the 3 10mm nuts that hold the lamp housing.

 

thx diablo,

you think a numbskull like me could do it???

 

Yes and when you succeed you won't be a numbskull!

(PS. I followed you!!!)

 

Can't speak to how to replace it, but I would JB Weld that sucker before shelling out for replacement. I have done so on many motorcycles.

 

The light should be fitted in the ring and it should be fitted in the car. But again it should be done from the front side not the back side.

 

The shims on the 10mm determine the spacing. there is no ring, just 3 screws.