Roof spoiler installation | FerrariChat
Buy

Roof spoiler installation

Discussion in '308/328' started by junkyarddog, Sep 8, 2006.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. junkyarddog

    junkyarddog Formula Junior

    May 18, 2006
    353
    Palatka, FL
    Full Name:
    Kelly Lake
    #1 junkyarddog, Sep 8, 2006
    I'm going to put a roof spoiler on my 308. I have seen comments on installing them with screws and installing them with expoy. Does anyone have a suggestion? I like the idea of not drilling into the engine lid but will it hold?
     
  2. enjoythemusic

    enjoythemusic F1 World Champ

    Apr 20, 2002
    10,676
    Worldwide
    Full Name:
    Steven
    #2 enjoythemusic, Sep 8, 2006
    Please bolt it on, that thing sees plenty of wind force.
     
  3. GrigioGuy

    GrigioGuy Splenda Daddy
    Lifetime Rossa Owner

    Nov 26, 2001
    33,161
    E ' ' '/ F
    Full Name:
    Snike Fingersmith
    #3 GrigioGuy, Sep 8, 2006
    +1

    Besides, my car is evidence that a great bodyshop can remove those holes without evidence, should you change your mind later.
     
  4. BigTex

    BigTex Seven Time F1 World Champ
    Owner Rossa Subscribed

    Dec 6, 2002
    79,386
    Houston, Texas
    Full Name:
    Bubba
    #4 BigTex, Sep 8, 2006
    I believe it should have studs on it, as mentioned....

    The one on Valeria's car required holes in the bottom of the lid, large enough to install nuts and washers from below. I assume this is the case in Factory installations.

    I suspect her's was dealer installed, in 1980.

    HTH
     

Share This Page