Rubber Seal for Dino Rear Lights

I recently went to a rubber manufacturing shop and paid to have molds made of the rear turn signal / backup and brake light seals (the 4 round lights in the rear) for my 1967 Dino Spyder 2.0L. The molds were made using the orignal seals and carry all the markings found on the original product. Even the flexiblity of the rubber was carefully formulated to be as close as possible to the original product (it is not brittle or stiff like NOS rubber that is 30+ years old). Anyway, I had a limited production run made and intend to sell the extras - to help off set the cost of the molds. The seals are not cheap but you will not need a replacement for a long time as it is new rubber and these are very good reproductions. Please email me directly at ajmarton "at" comcast "dot" net and I will provide details. Andrew in Los Angeles